TESLA'S CONNECTION TO COUNTER SPACE-INTRIGUING EXPERIMENTS

TESLA'S PREDICTION REALISED! DOLLARD'S "COUNTER SPACE CONNECTION", BEARDEN'S "FLOW OF ENERGY FROM THE VACUUM OF SPACE TIME"- ACHIEVED AND DEMONSTRATED! SUPPLY OF ENERGY WITHOUT A RETURN WIRE POWERING A LOAD-BONUS- WIRELESS ENERGY FREE FLIGHT OF A HELICOPTER AND A FLYING SAUCER!
Question, why is the electricity and/or heat not conducted or free flowing throughout the entire filament or conductor?
The answer in my own opinion is that well, in short it is but the filament heating and the electrical flow as demonstrated shows the electromagnetic wave as a nodal point created by a standing wave existing between the transmitter and receiving aerials.
Faraday's law of induction is a basic law of electromagnetism that predicts how a magnetic field will interact with an electric circuit to produce an electromotive force (EMF). The Maxwell--Faraday equation is a generalisation of Faraday's law, and forms one of Maxwell's equations.
These laws simply state that every time electricity changes its strength or its direction they will produce electromagnetic waves, but if we include the transmitter aerial and the receiver aerial we have two electromagnetic waves now, the first from the transmitter and the second wave that illuminates the light sources indicating that there is an electric current flowing in the receiving antenna this produces a wave of its own. So the wave travelling out meets the wave travelling back, one will push against the other and they cancel out, so only the peaks of the waves become evident, which is where the light sources illuminate.
 If I was to reform the receiver antenna into a loop the connection would be considered complete as a full wave, but the experiments show that the light source illuminates and is connected regardless of an actual physical connection, therefore a counter spatial connection exists in free space and is formed from three primary elements.
 A resistive load, the light source which dissipates energy therefore no energy is stored, a capacitor which stores energy in an electric field, there is little energy dissipation in the form of a field in an enclosed space, which is typically bounded by two parallel metallic plates and an insulator or dielectric between. The space surrounding the experiment will have a structure of capacity, and other structures will have other capacities.
And there is also an inductor which stores energy in a magnetic field, which also has no energy dissipation. The lines of force orientate themselves in close loops surrounding the axis of current flow that has given rise to them. The larger the space is between a current that flows within and its images or reflections from other surrounding inductors or aerials allow more energy to be stored in the resulting field.
Once set into motion the completion of the connection is not limited to an actual physical connection of opposite polarity requirements, it finds it own way to complete the circuit once it has commenced when energized by electromagnetic waves of a particular character.
This is why the light source remains illuminated regardless of whether it is earthed or not, it is for the same reason that a transient voltage spike, (that can only be stopped by additional components at best), is created when we switch on or off a generator, the energy is stored by the same phenomenon in question, which in my experiment is actually a series of energy spikes that are measured not in volts but in joules; a transient response defined by a mathematical product of voltage, current, and time.
These multitudes of voltage spikes are created by a rapid buildup and decay of the magnetic field, which induce energy into the aerial. Voltage spikes may be longitudinal (common) mode or metallic (normal or differential) mode.
The effect of these voltage spikes produces corresponding increases in current (current spike). However some voltage spikes may be created by current sources. Voltage would increase as necessary so that a constant current will flow. Currents from a discharging inductor is one example, an inductor is a medium that can store an electrical charge.
In free space it can also be in the form of the dielectricity from the surrounding medium of air. A dielectric is an electrical insulator that can be polarized by an applied electric field and creates the DIPOLE (two poles). The phenomena of formation of dipole is called Polarization (Analogous to magnetization of magnetic dipole).
Polarization can occur in 4 ways:- 1. Electronic Polarization, i.e. Cloud of electrons moves in direction of electric field.2. Orientation Polarization. 3. Space Charge Polarization.4. Atomic  Ionic Polarization.
So must be due to electronic polarization and/or a space charge polarization similar to a common form of energy storage device such as a parallel-plate capacitor or in my experiment the capacity of the surrounding structures and air, the "dielectric" in principle in free space.